Rapid tooling · Trial parts · Production handoff[email protected]+86 176 2030 0785
PROTOTYPE TOOLING
Project enquiries+86 176 2030 0785

Molded color and surface finish samples

Set up a repeatable comparison of color, texture and gloss for the resin and visible part surfaces your design uses.

Curved console with matte and gloss surfaces
AI application illustration

Compare samples under agreed conditions

Use the same viewing conditions and comparable resin and geometry. Review whether thickness, nearby surfaces or assembly affect the way color and finish are seen.

Keep an approved reference

Label the accepted sample with the resin grade, color reference and drawing revision. Record the acceptance method before deciding whether it can be used for the next trial or production review.

Define the appearance target

Identify the visible areas and supply a physical reference or agreed visual specification. Specify where gloss, texture or translucency may vary between surfaces.

Application reference

Protolabs tooling reference

Frequently asked questions

Can a color chip replace a molded sample?

It can guide color selection. Confirm final appearance on representative molded geometry when wall thickness, texture or assembly can affect the visual result.

Can I review more than one finish?

Describe the finishes and what decision the comparison should support. Agree on which sample or test surface can represent each finish before the trial.

Handoff from prototype mold to production → · 3D-Printed Prototype vs. Rapid Injection Tooling →

PROTOTYPE TOOLING

Discuss your drawing with OPINOX.

Resin grade and target color or physical reference

Discuss your project ↗
Ask about your project ↗